Brakes (Rear)

Disassembly

~3min read

DISASSEMBLY

PRECAUTION / NOTICE / HINT

NOTICE:

  • If the rear disc brake caliper assembly has been disassembled, bleed air from the rear disc brake caliper.

    Click here

  • Take care not to scratch, damage or apply excessive force to any of the internal components of the left rear disc brake caliper.
  • To prevent rust from forming inside the left rear disc brake caliper, perform removal and installation of the rear disc brake piston quickly.
  • Do not clean the inside of the left rear disc brake caliper with brake cleaner.
  • Do not remove any parts unless specified, and remove only the parts indicated.
  • When disassembling the left rear disc brake caliper, be sure to switch to pad replacement mode.

    Click here

PROCEDURE

1. REMOVE CYLINDER BOOT

(a) Using a fine-tip screwdriver with its tip wrapped in protective tape, remove the cylinder boot from the rear disc brake caliper.

NOTICE:

Take care not to scratch or damage the inside of the left rear disc brake caliper or the cylinder boot installation groove.

*a

Protective tape

2. REMOVE REAR DISC BRAKE PISTON

(a) To prevent scratches or other damage, insert a piece of cloth or similar between the rear disc brake piston and the rear disc brake caliper.

*a

Rag

(b) Using compressed air, gradually apply air to remove the rear disc brake piston from the rear disc brake caliper.

CAUTION:

  • Do not hold the rear disc brake caliper with any part of your hand between the rear disc brake caliper and the rear disc brake piston.
  • Do not place any part of your hand in front of the rear disc brake piston when using compressed air, as this may cause serious injury.

NOTICE:

Avoid splashing brake fluid.

3. REMOVE PISTON SEAL

(a) Using a screwdriver with its tip wrapped in protective tape, remove the piston seal from the rear disc brake caliper.

NOTICE:

  • Take care not to damage the inner surface or the piston seal groove of the rear disc brake caliper.
  • Prevent the nut from turning. If the nut turns accidentally, return it to its original position.

*a

Protective tape

*b

Nut

4. REMOVE REAR DISC BRAKE BLEEDER CAP

(a) Remove the rear disc brake bleeder cap and the rear disc brake bleeder plug.

5. REMOVE REAR DISC BRAKE BLEEDER PLUG

(a) Remove the rear disc brake bleeder plug from the rear disc brake caliper assembly.