Brakes (Rear)

Removal

~4min read

REMOVAL

PRECAUTION / NOTICE / HINT

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. PRECAUTIONS

Click here

2. REMOVE REAR WHEEL

Click here

3. PERFORM REAR BRAKE PAD REPLACEMENT MODE

Click here

4. DRAIN BRAKE FLUID

NOTICE:

If brake fluid leaks onto a painted surface, wipe it off immediately.

5. DISCONNECT REAR BRAKE HOSE

(a) Remove the union bolt and gasket, then disconnect the rear brake hose from the rear disc brake cylinder assembly.

6. DISCONNECT PARKING BRAKE CABLE ASSEMBLY NO. 2

(a) Disconnect the parking brake cable assembly No. 2 from the electric parking brake actuator assembly.

NOTICE:

  • Before performing this operation, remove dirt or foreign matter from around the connector.
  • Be careful not to let water, oil or dirt get into the No. 2 parking brake cable assembly connector.

7. REMOVE ELECTRIC PARKING BRAKE ACTUATOR ASSEMBLY

(a) Using a 5 mm hexagon socket wrench, remove the 2 bolts and the parking brake actuator assembly from the rear disc brake cylinder assembly.

NOTICE:

  • Check that there is no brake fluid leakage from the rear of the rear disc brake cylinder assembly.
  • If there is brake fluid leakage, replace the rear disc brake cylinder assembly.

(b) Remove the O-ring from the rear disc brake cylinder assembly.

8. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY

(a) Hold the 2 rear disc brake cylinder guide pins, then remove the 2 bolts and the rear disc brake cylinder assembly.

*a

Turn

*b

Hold

9. REMOVE REAR DISC BRAKE PAD

(a) Remove the 2 rear disc brake pads from the rear disc brake caliper support.

10. REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM KIT

Click here

11. REMOVE REAR DISC BRAKE PAD ABUTMENT PLATE

(a) Remove the 4 rear disc brake pad abutment plates from the rear disc brake caliper support.

NOTICE:

Each rear disc brake pad abutment plate has a different shape. Be sure to make identification marks on each rear disc brake pad abutment plate so they can be reinstalled in their original positions.

12. REMOVE REAR DISC BRAKE CALIPER SLIDE PIN

(a) Remove the No. 1 rear disc brake caliper slide pin and the No. 2 rear disc brake caliper slide pin from the rear disc brake caliper bracket.

*1

No. 1 rear disc brake caliper slide pin

*2

No. 2 rear disc brake caliper slide pin

(b) Using a screwdriver with its tip wrapped in protective tape, remove the rear disc brake caliper slide bushing from the No. 2 rear disc brake caliper slide pin.

NOTICE:

Do not damage the No. 2 rear disc brake caliper slide pin.

*a

Protective tape

13. REMOVE REAR DISC BRAKE BUSHING DUST BOOT

(a) Remove the 2 rear disc brake bushing dust boots from the rear disc brake caliper bracket.

14. REMOVE REAR DISC BRAKE CALIPER BRACKET

(a) Remove the 2 bolts and the rear disc brake caliper bracket from the rear axle carrier sub-assembly.

15. REMOVE REAR DISC

(a) Make alignment marks on the rear disc and the rear axle hub and bearing assembly.

*a

Alignment Mark

(b) Remove the rear disc from the rear axle hub and bearing assembly.