Brakes (Rear)

Inspection

~2min read
0408012016020010376N·mlb·ft
Tightening torque found on this page

INSPECTION

PROCEDURE

1. INSPECT BRAKE PAD LINING THICKNESS

(a) Using a ruler, measure the thickness of the rear disc brake pad lining.

Standard thickness:

9.5 mm (0.374 in.)

Minimum thickness:

1.0 mm (0.0394 in.)

If the thickness of the rear disc brake pad lining is less than the minimum, replace the rear disc brake pads.

HINT:

Be sure to inspect the rear disc thickness when replacing the rear disc brake pads with new ones.

*a

Ruler

2. INSPECT REAR DISC BRAKE PAD SHIM

(a) Make sure the rear disc brake pad shims have sufficient rebound, are not deformed, cracked or worn, and are free of rust and dirt. If necessary, replace the rear disc brake pad shims.

3. INSPECT DISC THICKNESS

(a) Using a micrometer, measure the thickness of the rear disc.

Standard thickness:

12.0 mm (0.472 in.)

Minimum thickness:

10.5 mm (0.413 in.)

If the thickness of the rear disc is less than the minimum, replace the rear disc.

*a

Micrometer

4. INSPECT DISC RUNOUT

(a) Check the rear axle hub and bearing for looseness and the rear axle hub for runout.

Click here

(b) Temporarily install the rear disc with the 5 hub nuts.

Torque:

103 N·m {1 050 kgf·cm, 76 ft·lbf}

(c) Using a dial indicator, measure the disc runout at 10 mm (0.394 in.) from the outer edge of the rear disc.

Maximum disc runout:

0.15 mm (0.00591 in.)

NOTICE:

Keep the dial indicator magnet away from the rear axle hub and bearing assembly and the rear speed sensor.

If the runout is greater than the maximum, change the installation position of the rear disc to minimize the runout. If the runout is still greater than the maximum after changing the installation position, resurface the rear disc. If the thickness of the rear disc is less than the minimum, replace the rear disc.

*a

Dial indicator

(d) Remove the 5 hub nuts and the rear disc.