Removal
REMOVAL
PROCEDURE
1. REMOVE REAR PACKAGE TRAY TRIM PANEL ASSEMBLY (with Rear Package Tray Trim)
Click here![]()
2. REMOVE SILL COVER ASSEMBLY (with Sill Cover)
Click here![]()
3. REMOVE LUGGAGE COMPARTMENT BOARD ASSEMBLY
Click here![]()
4. REMOVE SPARE WHEEL BED
Click here![]()
5. REMOVE LH LUGGAGE COMPARTMENT FLOOR BOX
Click here![]()
6. REMOVE RH LUGGAGE COMPARTMENT FLOOR BOX
Click here![]()
7. REMOVE REAR SEAT CUSHION ASSEMBLY (BENCH TYPE)
Click here![]()
8. REMOVE LH REAR DOOR SCUFF PLATE (without Rear Seat Side Airbag)
Click here![]()
9. REMOVE LH REAR DOOR SCUFF PLATE (with Rear Seat Side Airbag)
Click here![]()
10. DISCONNECT LH REAR DOOR OPENING TRIM WEATHERSTRIP
Click here![]()
11. REMOVE LH REAR SEAT BACK HINGE SUBASSEMBLY
Click here![]()
12. REMOVE LH REAR SEAT SIDE GARNISH (without Rear Seat Side Airbag)
Click here![]()
13. REMOVE LH REAR PILLAR GARNISH (with Rear Seat Side Airbag)
Click here![]()
14. REMOVE LH REAR SEAT SIDE GARNISH (with Rear Seat Side Airbag)
Click here![]()
15. REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER
Click here![]()
16. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
Click here![]()
17. REMOVE LH LUGGAGE COMPARTMENT SIDE TRIM PANEL ASSEMBLY
Click here![]()
18. REMOVE RADIO TUNER CAPACITOR
NOTICE:
When removing the terminal cover, the radio tuner capacitor must be replaced because the terminal cover and radio tuner capacitor are supplied as a set.
(a) Remove the bolt. |
![]() |
(b) Using a clip remover, release the clip to disconnect the radio tuner capacitor with wire harness from the body.
(c) Release the claw to remove the cover as shown in the illustration. |
![]() |
(d) Using a screwdriver, release the 6 claws to remove the 2 terminal covers with wire harness from the radio tuner capacitor. |
![]() |
(e) Using a screwdriver, bend and break the claw as shown in the illustration. |
![]() |
(f) Remove the terminal cover from the wire harness.
NOTICE:
- Be sure to hold the crimped side of the terminal when disconnecting the wire harness from the terminal cover.
- Be careful not to bend the exposed wire when disconnecting the wire harness from the terminal cover.
- Check that there is no deformation on the terminal after removing the wire harness from the terminal cover.



