Audio / Video
Inspection On Vehicle
INSPECTION ON VEHICLE
PROCEDURE
1. INSPECT RADIO TUNING CAPACITOR
(a) After installing the radio tuning capacitor, make sure there is no looseness or other abnormality.
(b) Measure the resistance of the radio tuning capacitor according to the value(s) in the table below.
Standard resistance:
Tester Connection | Condition | Specified Condition |
1 - Body Ground |
- Ignition Switch in OFF position
- High-Mounted Stop Light in OFF Position
- Rear Window Defogger in OFF Position
|
Below 1 Ω |
|
 |
*a |
Radio Tuning Capacitor |
|
|
(c) Remove the bolt.
(d) Release the clip and disconnect the radio tuning capacitor with wire harness from the vehicle body.
(e) Measure the resistance and voltage of the radio tuning capacitor according to the value(s) in the table below.
Standard resistance:
Tester Connection | Condition | Specified Condition |
1 - 2 |
- Ignition Switch in OFF position
- High-Mounted Stop Light in OFF Position
- Rear Window Defogger in OFF Position
|
10 kΩ minimum |
1 - 3 |
10 kΩ minimum |
Standard voltage:
Tester Connection | Condition | Specified Condition |
2 - Body Ground |
- Ignition Switch in ON position
- Rear Window Defogger in OFF Position
|
Below 1 V |
3 - Body Ground |
- Ignition Switch in ON position
- High-Mounted Stop Light in OFF Position
|
Below 1 V |
2 - Body Ground |
- Ignition Switch in ON position
- Rear Window Defogger in ON Position
|
11 à 14 V |
3 - Body Ground |
- Ignition Switch in ON position
- High-Mounted Stop Light in ON Position
|
11 à 14 V |
|
 |
*a |
Radio Tuning Capacitor |
|
|
Was this page helpful?