Brake Control / Dynamic Control Systems

Removal

~1min read

REMOVAL

PRECAUTION / NOTICE / HINT

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.
  • The front speed sensor rotor is an integral part of the front axle hub sub-assembly. If the front speed sensor rotor malfunctions, replace the front axle hub sub-assembly.

PROCEDURE

1. REMOVE FRONT WHEEL

Click here

2. REMOVE ROCKER PANEL MOULDING

Click here

3. SEPARATE FRONT FENDER APRON

(a) Remove the 4 screws.

(b) Remove the 3 clips and detach the front fender apron.

4. REMOVE FRONT SPEED SENSOR

(a) Turn over the front fender apron.

(b) Disconnect the connector.

(c) Release the body clamp.

(d) Release the body clamp.

(e) Remove the 2 bolts and detach the 2 front speed sensor brackets.

(f) Remove the bolt and detach the front hose and front speed sensor clamp from the front shock absorber assembly.

(g) Disengage the clamp from the front shock absorber assembly.

(h) Remove the bolt and front speed sensor from the steering knuckle.

NOTICE:

  • Keep the front speed sensor electrode and installation hole free of foreign matter.
  • Do not rotate or apply excessive force to the front speed sensor when removing it from the steering knuckle. Twisting or excessive force may damage the front speed sensor.