Seat Belt

Removal

~2min read

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) that must be performed after parts have been removed and installed or replaced during occupant detection sensor removal/installation are shown below.

Procedure Required After Replacing / Removing / Installing Parts

Replaced Part or Performed Procedure

Required Procedure

Effect/Inoperative Function When Required Procedure Is Not Performed

Link

Disconnect the cable from the negative (-) battery terminal.

Initialize Back Door Lock

Door Lock Control System

Memorize Steering Angle Neutral Point

Lane Departure Alert System (with Steering Control)

Pre-Collision System

CAUTION:

  • Some service operations affect the SRS airbag system. Before starting any service operation, carefully read the precautions for the SRS airbag system.

    Click here

  • Wear protective gloves. Sharp edges on parts may cause injury to your hands.

PROCEDURE

1. REMOVE FRONT SEAT ASSEMBLY

HINT:

Perform the same procedure as for the driver side.

Click here

2. REMOVE FRONT SEAT BELT INNER BELT ASSEMBLY

Click here

3. DISCONNECT FRONT SEAT BACK COVER (SEPARATE TYPE)

HINT:

Perform the same procedure as for the driver side.

Click here

4. REMOVE RECLINING ADJUSTER OUTER HINGE COVER

HINT:

Perform the same procedure as for the driver side.

Click here

5. REMOVE RECLINING ADJUSTER RELEASE HANDLE

HINT:

Perform the same procedure as for the driver side.

Click here

6. REMOVE FRONT SEAT CUSHION SHIELD

Click here

7. REMOVE FRONT SEAT INNER CUSHION SHIELD

Click here

8. REMOVE FRONT SEATBACK ASSEMBLY (SEPARATE TYPE)

HINT:

Perform the same procedure as for the driver side.

Click here

9. REMOVE FRONT SEAT CUSHION COVER (SEPARATE TYPE) WITH CUSHION PAD

HINT:

Perform the same procedure as for the driver side.

Click here

10. REMOVE OCCUPANT DETECTION SENSOR (FRONT SEAT CUSHION PAD, SEPARATE TYPE)

(a) Using a screwdriver, release the claws to remove the occupant detection sensor (front seat cushion pad, separate type) from the front seat cushion cover (separate type) as shown in the illustration.

*a

Screwdriver

-

-