Removal
REMOVAL
PRECAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front seat belt inner belt assembly removal/installation, are shown below.
Procedure Required After Replacing / Removing / Installing PartsReplaced Part or Performed Procedure | Required Procedure | Effect/Inoperative Function When Required Procedure Is Not Performed | Link |
|---|---|---|---|
Disconnect the cable from the negative (-) battery terminal. |
Initialize Back Door Lock |
Door Lock Control System |
|
Memorize Steering Angle Neutral Point |
Lane Departure Alert System (with Steering Control) |
||
Pre-Collision System |
CAUTION:
- Some service operations affect the SRS airbag system. Before starting any service operation, carefully read the precautions for the SRS airbag system.
Click here
.gif)
- Wear protective gloves. Sharp edges on parts may cause injury to your hands.
HINT:
- Perform the same procedure for the driver side and front passenger side.
- The procedure below applies to the driver side.
PROCEDURE
1. REMOVE FRONT SEAT ASSEMBLY
Click here![]()
2. REMOVE FRONT SEAT BELT INNER BELT ASSEMBLY (for Driver Side)
(a) without Occupant Classification System:
(1) Release the clip and claw. |
![]() |
(b) with Occupant Classification System:
(1) Disconnect the connector. |
![]() |
(2) Release the clip and claw.
(c) Release the clips. |
![]() |
(d) Remove the nut and front seat belt inner belt assembly.
(e) Remove the front seat belt anchor plate.
3. REMOVE FRONT SEAT BELT INNER BELT ASSEMBLY (for Front Passenger Side)
(a) without Occupant Classification System:
(1) Disconnect the connector. |
![]() |
(2) Release the clips and claw.
(3) Release the clip. |
![]() |
(4) Remove the nut and front seat belt inner belt assembly.
(5) Remove the front seat belt anchor plate.
(b) with Occupant Classification System:
(1) Release the clip and claw. |
![]() |
(2) Release the clips. |
![]() |
(3) Remove the nut and the front seat belt inner belt assembly.
(4) Remove the front seat belt anchor plate.






