INSPECTION
PROCEDURE
1. INSPECT FRONT SEAT BELT INNER BELT ASSEMBLY (for Driver Side)
(a) without Occupant Classification System:
(1) Check the resistance.
- Measure the resistance according to the value(s) specified in the table below.
Standard resistance:
Tester Connection | Condition | Specified Condition |
M73-3 (+) - M73-2 (E) |
Driver side seat belt unbuckled |
Below 1 Ω |
Driver side seat belt buckled |
10 kΩ minimum |
If the result is not as specified, replace the front seat belt inner belt assembly. |
 |
*a |
Component without wire harness connected
(Front Seat Belt Inner Belt Assembly) |
|
|
(b) with Occupant Classification System:
(1) Check the resistance.
- Measure the resistance according to the value(s) specified in the table below.
Standard resistance:
Tester Connection | Condition | Specified Condition |
M101-3 (LSP-) - A-1 |
Always |
Below 1 Ω |
M101-4 (LSP+) - A-2 |
Always |
Below 1 Ω |
If the result is not as specified, replace the front seat belt inner belt assembly. |
 |
*a |
Component without wire harness connected
(Front Seat Belt Inner Belt Assembly) |
|
|
2. INSPECT FRONT SEAT BELT INNER BELT ASSEMBLY (for Front Passenger Side)
(a) without Occupant Classification System:
(1) Check the resistance.
- Measure the resistance according to the value(s) specified in the table below.
Standard resistance:
Tester Connection | Condition | Specified Condition |
M53-2 (E) - B-3 |
Front passenger seat belt unbuckled |
Below 1 Ω |
Front passenger seat belt buckled |
10 kΩ minimum |
M53-3 (+) - B-1 |
Always |
Below 1 Ω |
If the result is not as specified, replace the front seat belt inner belt assembly. |
 |
*a |
Component without wire harness connected
(Front Seat Belt Inner Belt Assembly) |
|
|
Was this page helpful?