Removal
REMOVAL
PRECAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during combination meter removal/installation are indicated below.
Procedure Required After Replacing / Removing / Installing PartsReplacement part or procedure | Necessary Procedures | Effects / Inoperative Function When Necessary Procedure Not Performed | Link |
|---|---|---|---|
Disconnect the cable from the negative (-) battery terminal. |
Initialize Back Door Lock |
Door Lock Control System |
|
Memorize Steering Angle Neutral Point |
Lane Departure Alert System (with Steering Control) |
||
Pre-Collision System |
PROCEDURE
1. PRECAUTIONS
NOTICE:
After turning the ignition switch OFF, a waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, be sure to read the precautions for disconnecting the cable from the negative (-) battery terminal before performing the work.
Click here
![]()
2. DISCONNECT THE CABLE FROM THE NEGATIVE BATTERY TERMINAL
Click here![]()
NOTICE:
When the cable has been disconnected, some systems must be reset after the cable is reconnected.
Click here
![]()
3. REMOVE COMBINATION METER FINISH PANEL SUB-ASSEMBLY
Click here
![]()
4. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY
Click here
![]()
5. REMOVE COMBINATION METER FINISH PANEL ASSEMBLY
Click here
![]()
6. REMOVE INSTRUMENT PANEL FINISH SUB-ASSEMBLY NO. 2
Click here
![]()
7. REMOVE COMBINATION METER ASSEMBLY
(a) Remove the 2 screws. |
![]() |
(b) Release the clips and guides.
(c) Disconnect the 2 connectors to remove the combination meter assembly. |
![]() |
.gif)

