Removal
REMOVAL
PRECAUTION / NOTICE / HINT
Necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts have been removed, installed or replaced during front seat cushion heater assembly removal/installation are shown below.
Procedure Required After Replacing / Removing / Installing PartsReplacement part or procedure | Necessary Procedures | Effects / Inoperative Function When Necessary Procedure Not Performed | Link |
|---|---|---|---|
Disconnect the cable from the negative (-) battery terminal. |
Initialize Back Door Lock |
Door Lock Control System |
|
Memorize Steering Angle Neutral Point |
Lane Departure Alert System (with Steering Control) |
||
Pre-Collision System |
CAUTION:
- Be sure to read the Precautions carefully before performing maintenance.
Click here
.gif)
.png)
- Wear protective gloves. Sharp edges on parts may cause injury to your hands.
HINT:
- Follow the same procedure for both RHD and LHD vehicles.
- The procedure listed below is for LHD.
- Perform the same procedure for the driver side and front passenger side.
- The procedure below applies to the driver side.
PROCEDURE
1. REMOVE FRONT SEAT BACK ASSEMBLY (SEPARATE TYPE)
Click here![]()
2. REMOVE FRONT SEAT CUSHION COVER (SEPARATE TYPE) WITH PAD
Click here
![]()
3. REMOVE FRONT SEAT CUSHION COVER (SEPARATE TYPE)
Click here
![]()
4. REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY
(a) Remove the 14 label clips and the front seat cushion heater assembly from the front seat cushion cover (separate type).