Supplemental Restraint Systems

Removal

~3min read

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) that must be performed after parts have been removed, installed or replaced during removal/installation of the spiral cable sub-assembly are listed below.

Procedure Required After Replacing / Removing / Installing Parts

Replacement part or procedure

Necessary Procedures

Effects / Inoperative Function When Necessary Procedure Not Performed

Link

Disconnect the cable from the negative (-) battery terminal.

Initialize Back Door Lock

Door Lock Control System

Memorize Steering Angle Neutral Point

Lane Departure Alert System (with Steering Control)

Pre-Collision System

PROCEDURE

1. REMOVE STEERING WHEEL ASSEMBLY

Click here

2. ALIGN FRONT WHEELS STRAIGHT AHEAD

3. INSPECT SPIRAL CABLE SUB-ASSEMBLY WITH SENSOR (without steering heater system)

(a) Check the flat cable as shown in the diagram.

If the flat cable shown in the diagram is not visible, the spiral cable sub-assembly with sensor may be damaged. Replace the spiral cable sub-assembly with sensor with a new one.

*a

Flat Cable

4. INSPECT SPIRAL CABLE SUB-ASSEMBLY WITH SENSOR (with steering heater system)

(a) Check the flat cable as shown in the diagram.

If the flat cable shown in the diagram is not visible, the spiral cable sub-assembly with sensor may be damaged. Replace the spiral cable sub-assembly with sensor with a new one.

*a

Flat Cable

5. REMOVE STEERING COLUMN LOWER COVER SUB-ASSEMBLY

Click here

6. REMOVE STEERING COLUMN UPPER COVER

Click here

7. REMOVE SPIRAL CABLE SUB-ASSEMBLY WITH SENSOR

NOTICE:

  • Do not replace the spiral cable sub-assembly with sensor while the battery is connected and the ignition switch is in the ON position.
  • Do not rotate the spiral cable sub-assembly with sensor without locking the installed steering wheel assembly, with the battery connected and the ignition switch in the ON position.
  • Make sure the steering wheel assembly is installed and in the straight-ahead position when checking the steering angle sensor.

(a) Make sure the ignition switch is in the OFF position.

(b) Make sure the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Make sure the front wheels are aligned straight ahead.

(d) Slide the lock to release the lock, then disconnect the yellow airbag connector from the spiral cable sub-assembly with sensor.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.

*a

Slider

(e) Disconnect each connector from the spiral cable sub-assembly with sensor.

(f) Release the claws to remove the spiral cable sub-assembly with sensor.

NOTICE:

  • Do not remove the steering angle sensor from the spiral cable sub-assembly with sensor.
  • If the steering angle sensor malfunctions, replace the spiral cable sub-assembly with sensor together with the steering angle sensor.