Removal
REMOVAL
PRECAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts have been removed, installed or replaced during removal/installation of the seat position airbag sensor are shown below.
Procedure Required After Replacing / Removing / Installing PartsReplacement part or procedure | Necessary Procedures | Effects / Inoperative Function When Necessary Procedure Not Performed | Link |
|---|---|---|---|
Disconnect the cable from the negative (-) battery terminal. |
Memorize Steering Angle Neutral Point |
Lane Departure Alert System (with Steering Control) |
|
Pre-Collision System |
|||
Initialize Back Door Lock |
Door Lock Control System |
PROCEDURE
1. REMOVE FRONT SEAT ASSEMBLY
Click here![]()
2. REMOVE SEAT SLIDE POSITION SENSOR COVER
(a) Release the clip and disconnect the connector. |
![]() |
(b) Pull the seat slide position sensor cover in the direction indicated by the arrow (1) to release the pin, then slide the seat slide position sensor cover in the direction indicated by the arrows (2) as shown in the illustration to remove it.
![]() |
Remove in this direction (1) |
![]() |
Remove in this direction (2) |
3. REMOVE SEAT POSITION AIRBAG SENSOR
(a) Using a "TORX" T30 socket wrench, remove the bolt and the seat position airbag sensor. |
![]() |
.gif)
.png)
.png)
.png)
