Supplemental Restraint Systems

Installation

~2min read
0102030405086N·mlb·ft
Tightening torque found on this page

INSTALLATION

PROCEDURE

1. INSTALL SEAT POSITION AIRBAG SENSOR

(a) Insert the pin into the installation hole and temporarily install the seat position airbag sensor to the seat rail bracket with the bolt, as shown in the illustration.

*a

Pin

*b

Installation Hole

(b) Using a T30 "TORX" socket wrench and a 1.3 mm (0.0512 in.) thickness gauge, install the seat position airbag sensor with the "TORX" bolt.

Torque:

8 N·m {82 kgf·cm, 71 in·lbf}

NOTICE:

  • If the seat position airbag sensor has been dropped, or if the case or connector is cracked, nicked or otherwise damaged, replace the seat position airbag sensor with a new one.
  • When installing the seat position airbag sensor, make sure that the SRS wire harness is not interfering with or pinched between other parts.

*1

Seat Position Airbag Sensor

*a

Thickness Gauge

*b

1.3 mm (0.0512 in.)

*c

Seat Slide Rail Bracket

(c) Make sure that the clearance between the seat position airbag sensor and the seat slide rail bracket is 1.3 mm (0.0512 in.).

(d) Check that the installed seat position airbag sensor assembly parts are not loose.

2. INSTALL SEAT SLIDE POSITION SENSOR COVER

(a) Insert the seat slide position sensor cover into the seat rail bracket and engage the pin in the installation area of the seat slide position sensor cover.

*a

Seat Rail Bracket

*b

Pin

*c

Installation Area

Install in this direction (1)

Install in this direction (2)

(b) Connect the connector and engage the clip.

3. INSTALL FRONT SEAT ASSEMBLY

Click here