Supplemental Restraint Systems

Removal

~1min read

REMOVAL

PRECAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts have been removed, installed or replaced during removal/installation of the occupant classification ECU are shown below.

Procedure Required After Replacing / Removing / Installing Parts

Replacement part or procedure

Necessary Procedures

Effects / Inoperative Function When Necessary Procedure Not Performed

Link

  • Occupant Classification ECU Replacement
  • Front Passenger Seat Removal/Installation

Zero Point Calibration (Occupant Classification System)

  • Occupant Classification System
  • Passenger Airbag ON/OFF Indicator
  • Airbag System (Front Passenger Side)
  • Seat Belt Reminder System (Front Passenger)

Disconnect the cable from the negative (-) battery terminal.

Memorize Steering Angle Neutral Point

Lane Departure Alert System (with Steering Control)

Pre-Collision System

Initialize Back Door Lock

Door Lock Control System

PROCEDURE

1. REMOVE FRONT SEAT ASSEMBLY RH

HINT:

Perform the same procedure as for the left side.

Click here

2. REMOVE OCCUPANT CLASSIFICATION ECU

(a) Disconnect the 2 connectors.

*a

Protective tape

(b) Using a screwdriver with its tip wrapped in protective tape, release the claw and remove the occupant classification ECU.