Supplemental Restraint Systems
Installation
In this manual: Supplemental Restraint Systems
~1min read
INSTALLATION
PROCEDURE
1. INSTALL OCCUPANT CLASSIFICATION ECU
(a) Engage the claw to install the occupant classification ECU. NOTICE: If the occupant classification ECU has been dropped, or if the case or connector has cracks, nicks or other defects, replace the occupant classification ECU with a new one. |
![]() |
(b) Connect the 2 connectors.
NOTICE:
When installing the occupant classification ECU, make sure that the SRS wire harness does not interfere with or get pinched between other parts.
2. INSTALL FRONT SEAT ASSEMBLY RH
HINT:
Perform the same procedure as for the left side.
Click here![]()
3. PERFORM DIAGNOSTIC SYSTEM CHECK
Click here![]()
4. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK
Click here![]()
Was this page helpful?
