Supplemental Restraint Systems

Removal

~2min read

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) that must be performed after parts have been removed, installed or replaced during removal/installation of the front seat RH cushion airbag assembly are shown below.

Procedure Required After Replacing / Removing / Installing Parts

Replacement part or procedure

Necessary Procedures

Effects / Inoperative Function When Necessary Procedure Not Performed

Link

Front Passenger Seat Removal/Installation

Zero Point Calibration (Occupant Classification System)

  • Occupant Classification System
  • Passenger Airbag ON/OFF Indicator
  • Airbag System (Front Passenger Side)
  • Seat Belt Reminder System (Front Passenger)

Disconnect the cable from the negative (-) battery terminal.

Memorize Steering Angle Neutral Point

Lane Departure Alert System (with Steering Control)

Pre-Collision System

Initialize Back Door Lock

Door Lock Control System

  • Be sure to read the Precautions carefully before performing maintenance.

    Click here

  • Wear protective gloves. Sharp edges on parts may cause injury to your hands.

NOTICE:

If the front seat RH cushion airbag assembly has deployed, replace the front seat RH cushion airbag sub-assembly, the front seat RH adjuster assembly, the separate type front seat cushion pad and the separate type front seat cushion cover with new parts as necessary, depending on the extent of collision damage.

Click here

PROCEDURE

1. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

Click here

2. REMOVE FRONT SEAT RH CUSHION AIRBAG ASSEMBLY

CAUTION:

When storing the front seat RH cushion airbag assembly, make sure the airbag deployment side is facing up.

Deployment side

(a) Release the clips and the claw.

HINT:

Start by releasing the clips.

(b) Remove the 3 nuts.

NOTICE:

  • Do not reuse the nuts.
  • Make sure that the front seat adjuster assembly RH is not deformed. If deformed, replace it with a new one.

(c) Pass the airbag wire harness through the hole to remove the front seat RH cushion airbag assembly.