Supplemental Restraint Systems

Installation

~1min read
010203040505.54N·mlb·ft
Tightening torque found on this page

INSTALLATION

PROCEDURE

1. INSTALL FRONT SEAT CUSHION AIRBAG ASSEMBLY RH

(a) Pass the airbag wire harness through the hole.

(b) Install the front seat cushion airbag assembly RH with 3 new nuts.

Torque:

5.5 N·m {56 kgf·cm, 49 in·lbf}

NOTICE:

  • Do not reuse the nuts.
  • Make sure that the front seat adjuster assembly RH is not deformed. If deformed, replace it with a new one.

(c) Engage the claw and clips.

HINT:

Engage the claw first.

2. INSTALL FRONT SEAT CUSHION COVER (SEPARATE TYPE) WITH CUSHION PAD

Click here

3. PERFORM DIAGNOSTIC SYSTEM CHECK

Click here