Supplemental Restraint Systems

Removal

~3min read

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during No. 1 lower instrument panel airbag assembly removal/installation are shown below.

Procedure Required After Replacing / Removing / Installing Parts

Replacement part or procedure

Necessary Procedures

Effects / Inoperative Function When Necessary Procedure Not Performed

Link

Disconnect the cable from the negative (-) battery terminal.

Initialize Back Door Lock

Door Lock Control System

Memorize Steering Angle Neutral Point

Lane Departure Alert System (with Steering Control)

Pre-Collision System

PROCEDURE

1. PRECAUTIONS

CAUTION:

Be sure to read the Precautions carefully before performing maintenance.

Click here

NOTICE:

After turning the ignition switch OFF, a waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, be sure to read the precautions for disconnecting the cable from the negative (-) battery terminal before performing the work.

Click here

2. DISCONNECT THE CABLE FROM THE NEGATIVE BATTERY TERMINAL

Click here

CAUTION:

  • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
  • If any Supplemental Restraint System (SRS) component is accidentally deployed, serious injury may result.

NOTICE:

When the cable has been disconnected, some systems must be reset after the cable is reconnected.

Click here

3. REMOVE FUSE BOX OPENING COVER

Click here

4. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY

Click here

5. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL

Click here

6. REMOVE NO. 1 LOWER INSTRUMENT PANEL AIRBAG ASSEMBLY WITH DOOR

CAUTION:

When storing the No. 1 lower instrument panel airbag assembly with door, make sure the airbag deployment side is facing upward.

Deployment side

(a) Make sure the ignition switch is in the OFF position.

(b) Make sure the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Remove the 2 bolts.

(d) Release the claws to detach the No. 1 lower instrument panel airbag assembly with door.

NOTICE:

When separating the No. 1 lower instrument panel airbag assembly with door, do not pull on the airbag wire harness.

(e) Using a screwdriver with its tip wrapped in protective tape, unlock the airbag connector lock.

*a

Protective tape

*b

Airbag connector

*c

Airbag Connector Lock

(f) Disconnect the airbag connector to remove the No. 1 lower instrument panel airbag assembly with door.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.

7. REMOVE NO. 1 LOWER INSTRUMENT PANEL AIRBAG DOOR (TMMT made)

(a) Release the claws.

(b) Release the claws to remove the No. 1 lower instrument panel airbag door from the No. 1 lower instrument panel airbag assembly.