Supplemental Restraint Systems

Removal

5steps
~30min
2/5difficulty
Done 0 of 5

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) after parts have been removed, installed or replaced during removal/installation of the airbag sensor assembly are shown below.

Procedure Required After Replacing / Removing / Installing Parts

Replacement part or procedure

Necessary Procedures

Effects / Inoperative Function When Necessary Procedure Not Performed

Link

Disconnect the cable from the negative (-) battery terminal.

Initialize Back Door Lock

Door Lock Control System

Memorize Steering Angle Neutral Point

Lane Departure Alert System (with Steering Control)

Pre-Collision System

Replacement of Airbag Sensor Assembly

  1. Clear the zero point calibration data.
  2. Perform zero point calibration of the yaw rate and acceleration sensor.
  • DTCs are stored
  • ABS warning light comes on
  • Skid control warning light comes on
  • VSC OFF or malfunctioning
  1. Reset memory
  2. Deceleration sensor zero point calibration
  3. CVT oil pressure calibration

Fuel economy deterioration

PROCEDURE

1. PRECAUTIONS

CAUTION:

Be sure to read the Precautions carefully before performing maintenance.

Click here

NOTICE:

After turning the ignition switch OFF, a waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, be sure to read the precautions for disconnecting the cable from the negative (-) battery terminal before performing the work.

Click here

2. DISCONNECT THE CABLE FROM THE NEGATIVE BATTERY TERMINAL

Click here

  • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
  • If any Supplemental Restraint System (SRS) component is accidentally deployed, serious injury may result.

NOTICE:

When the cable has been disconnected, some systems must be reset after the cable is reconnected.

Click here

3. REMOVE REAR CONSOLE BOX ASSEMBLY

Click here

4. REMOVE NO. 2 REAR AIR DUCT (with rear air duct)

(a) Release the claws to remove the No. 2 rear air duct, as shown in the illustration.

Remove in this direction (1)

Remove in this direction (2)

5. REMOVE AIRBAG SENSOR ASSEMBLY

(a) Make sure the ignition switch is in the OFF position.

(b) Make sure the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Remove the clip and turn over the front floor carpet assembly as shown in the illustration (for left side).

(d) Remove the clip and turn over the front floor carpet assembly as shown in the illustration (for right side).

(e) Disconnect the airbag sensor assembly connectors as shown in the illustration.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.

Release in this direction

(f) Remove the 3 bolts and the airbag sensor assembly.