Supplemental Restraint Systems

Inspection On Vehicle

~1min read

INSPECTION ON VEHICLE

PRECAUTION / NOTICE / HINT

CAUTION:

Be sure to follow the correct removal and installation procedures for the airbag sensor assembly.

PROCEDURE

1. INSPECT AIRBAG SENSOR ASSEMBLY (vehicle not involved in collision)

(a) Perform a diagnostic system check.

Click here

2. INSPECT AIRBAG SENSOR ASSEMBLY (vehicle involved in collision without airbag deployment)

(a) Perform a diagnostic system check.

Click here

(b) Visually check for defects with the airbag sensor assembly installed in the vehicle.

HINT:

Defects include the following:

  • Cracks in ECU case
  • Nicks in ECU case
  • Chips in ECU case
  • Cracks or other damage to the connectors
  • Torn label

OK:

There are no defects.

If any of these defects are found, replace the airbag sensor assembly with a new one.

3. INSPECT AIRBAG SENSOR ASSEMBLY (vehicle involved in collision with airbag deployment)

(a) Replace the airbag sensor assembly.

HINT:

The airbag sensor assembly must be replaced whenever an SRS component has deployed, since it has been subjected to impact.