Supplemental Restraint Systems

Installation

~2min read
0102030405017.513N·mlb·ft
Tightening torque found on this page

INSTALLATION

PROCEDURE

1. INSTALL AIRBAG SENSOR ASSEMBLY

(a) Make sure the ignition switch is in the OFF position.

(b) Make sure the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Install the airbag sensor assembly with the 3 bolts.

Torque:

17.5 N·m {178 kgf·cm, 13 ft·lbf}

NOTICE:

  • If the airbag sensor assembly has been dropped, or if the housing or connector has cracks, nicks or other defects, replace it with a new one.
  • When installing the airbag sensor assembly, make sure the SRS wiring does not interfere with or get pinched between other parts.
  • When the ignition switch is turned ON for the first time after replacing the airbag sensor assembly, make sure no one is inside the vehicle.

(d) Connect the connectors to the airbag sensor assembly as shown in the illustration.

Install in this direction

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.

(e) without rear air duct:

(1) Check that the waterproof sheet is correctly positioned.

(f) Make sure the installed parts of the airbag sensor assembly are not loose.

(g) Turn over the front floor carpet assembly and install the clip as shown in the illustration (for LH side).

(h) Turn over the front floor carpet assembly and install the clip as shown in the illustration (for RH side).

2. INSTALL REAR AIR DUCT NO. 2 (with rear air duct)

(a) Engage the claws to install the No. 2 rear air duct as shown in the illustration.

Install in this direction (1)

Install in this direction (2)

(b) Make sure the waterproof sheet is correctly installed as shown in the illustration.

*a

Waterproof Sheet

3. INSTALL REAR CONSOLE BOX ASSEMBLY

Click here

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Click here

NOTICE:

When the cable has been disconnected, some systems must be reset after the cable is reconnected.

Click here

5. PERFORM DIAGNOSTIC SYSTEM CHECK

Click here

6. CHECK SRS WARNING LIGHT

Click here

7. PERFORM ZERO POINT CALIBRATION OF YAW AND ACCELERATION SENSOR

(a) When the airbag sensor assembly has been replaced, perform zero point calibration.

Click here

HINT:

The yaw rate and acceleration sensor is built into the airbag sensor assembly.