Front Suspension

Removal

2steps
~27min
3/5difficulty
3special tools
Done 0 of 2

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required after removing and installing or replacing parts during removal/installation of the front lower ball joint assembly are listed below.

Procedures Required After Replacement / Removal / Installation of Parts

Replaced Part or Performed Procedure

Required Procedure

Effect/Inoperative Function When Required Procedure Is Not Performed

Link

Front wheel alignment adjustment

  1. Clear the zero point calibration data.
  2. Perform zero point calibration of the yaw rate and acceleration sensor.
  • DTCs are stored
  • ABS warning light comes on
  • Skid control warning light comes on
  • VSC OFF or malfunctioning

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. REMOVE FRONT AXLE ASSEMBLY

Click here

2. REMOVE FRONT LOWER BALL JOINT ASSEMBLY

(a) Clamp the front axle assembly in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.

(b) Remove the cotter pin.

(c) Remove the nut.

(d) Install the SST onto the front lower ball joint assembly as shown in the illustration.

SST: 09960-20010

09961-02050

NOTICE:

Check that the clearance measured between the SST and the front axle assembly is 1 mm (0.0394 in.).

*a

1 mm (0.0394 in.)

(e) Using the SST, remove the front lower ball joint assembly from the front axle assembly as shown in the illustration.

SST: 09960-20010

09961-02010

09961-02050

*a

Center nut

*b

Molybdenum disulfide grease application area

*c

Place wrench at this location

*d

String

Turn

NOTICE:

  • Apply molybdenum grease to the threads and end of the SST bolt.
  • Reinstall the SST with the center nut so that (A) and (B) shown in the illustration are parallel. Otherwise, the front lower ball joint dust boot may be damaged.
  • Be sure to place a wrench at the position shown in the illustration.
  • Do not damage the front lower ball joint dust cover.
  • Do not damage the steering knuckle.
  • Do not damage the front disc brake dust cover.