Front Suspension

Inspection

~1min read

INSPECTION

PROCEDURE

1. INSPECT FRONT LOWER BALL JOINT ASSEMBLY

(a) Inspect the ball joint swivel torque.

(1) Clamp the front lower ball joint assembly in a vise between aluminum plates.

(2) Install the nut onto the stud of the front lower ball joint assembly.

(3) Using a torque wrench, turn the stud continuously at a rate of one turn every 3 to 5 seconds, and read the torque value on the 5th turn.

Rotation torque:

0.98 to 3.43 N*m (10 to 34 kgf*cm, 9 to 30 lbf*in)

HINT:

If the torque value is not within the specified range, replace the front lower ball joint assembly with a new one.

(4) Turn the stud to make sure the stud does not bind and there is no play.

HINT:

If the stud binds or there is play when it turns, replace the front lower ball joint assembly with a new one.

(b) Inspect the dust boot.

(1) Check that the dust boot is not cracked and has no grease on it.

HINT:

If the dust cover is cracked or there is MP grease inside it, replace the front lower ball joint assembly with a new one.