Front Suspension

Installation

~1min read
0408012016020013398N·mlb·ft
Tightening torque found on this page

INSTALLATION

PRECAUTION / NOTICE / HINT

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. INSTALL FRONT LOWER BALL JOINT ASSEMBLY

(a) Clamp the front axle assembly in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.

(b) Install the front lower ball joint assembly to the front axle assembly with the nut.

Torque:

133 N·m {1,356 kgf·cm, 98 ft·lbf}

NOTICE:

  • Do not apply lubricant to the taper or threads of the ball joint stud.
  • Remove any foreign matter from the contact surface of the tapered threaded ball joint stud and the steering knuckle.

(c) Install a new cotter pin.

NOTICE:

If the cotter pin holes are not aligned, continue tightening the nut by up to 60°.

2. INSTALL FRONT AXLE ASSEMBLY

Click here