K114 Continuously Variable Transmission

Removal

3steps
~23min
2/5difficulty
1special tools
Done 0 of 3

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during oil pressure sensor removal/installation are shown below.

Procedure Required After Replacing / Removing / Installing Parts

Replacement part or procedure

Required Procedure

Effect/Inoperative function when procedure not performed

Link

Replacement of Oil Pressure Sensor

Follow the procedures below in the order shown:

  1. Reset memory
  2. Deceleration sensor zero point calibration
  3. CVT oil pressure calibration

Fuel economy deterioration

PROCEDURE

1. REMOVE FRONT WHEEL LH

Click here

2. REMOVE ENGINE UNDER COVER NO. 1

Click here

3. REMOVE ENGINE UNDER COVER REAR LH

Click here

4. REMOVE OIL PRESSURE SENSOR

(a) Disconnect the oil pressure sensor connector.

(b) Using the SST, remove the oil pressure sensor from the continuously variable transaxle assembly.

SST: 09326-22011