K114 Continuously Variable Transmission

Installation

~1min read
1special tools
0102030405020.615N·mlb·ft
Tightening torque found on this page

INSTALLATION

PROCEDURE

1. INSTALL OIL PRESSURE SENSOR

(a) Apply genuine Toyota CVT FE fluid to the O-ring of the oil pressure sensor.

NOTICE:

If reusing the oil pressure sensor, make sure the O-ring is not damaged.

(b) Using the SST, install the oil pressure sensor to the continuously variable transaxle assembly.

SST: 09326-22011

Torque:

Specified torque:

21 N·m {210 kgf·cm, 15 ft·lbf}

HINT:

  • Calculate the torque wrench reading when changing the torque wrench lever length.

    Click here

  • When using the SST (lever length 50 mm (1.9685 in.)) + torque wrench (lever length 180 mm (7.0866 in.)): 16.1 N*m (164 kgf*cm, 12 ft*lbf)

*a

SST lever arm length

*b

Torque wrench lever length

(c) Reconnect the oil pressure sensor connector.

2. INSTALL REAR LH ENGINE UNDER COVER

Click here

3. INSTALL NO. 1 ENGINE UNDER COVER

Click here

4. INSTALL FRONT WHEEL LH

Click here

5. RESET MEMORY

Click here