K114 Continuously Variable Transmission

Removal

~2min read

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during CVT transaxle oil pan sub-assembly removal/installation are shown below.

Procedure Required After Replacing / Removing / Installing Parts

Replacement part or procedure

Required Procedure

Effect/Inoperative function when procedure not performed

Link

CVT Fluid Replacement

ATF Thermal Degradation Estimate Reset

The value of the "ATF Thermal Degradation Estimate" Data List item is not estimated correctly.

PROCEDURE

1. REMOVE NO. 1 ENGINE UNDER COVER

Click here

2. REMOVE REAR LEFT ENGINE UNDER COVER

Click here

3. REMOVE TRANSAXLE OIL PAN SUB-ASSEMBLY (CVT)

(a) Remove the filler plug and gasket from the continuously variable transmission assembly.

(b) Using a 10 mm hexagon socket wrench, remove the drain plug and gasket from the continuously variable transmission (CVT) oil pan sub-assembly and drain the fluid.

(c) Using a 6 mm hexagon socket wrench, remove the overflow plug and gasket from the CVT transaxle oil pan sub-assembly.

(d) Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler pipe from the CVT transaxle oil pan sub-assembly.

HINT:

Removing the No. 1 transmission oil filler pipe will drain all of the oil from the CVT transaxle oil pan sub-assembly.

*1

No. 1 Transmission Oil Filler Pipe

(e) Remove the 19 bolts, CVT transaxle oil pan sub-assembly and CVT transaxle oil pan gasket from the continuously variable transmission transaxle assembly.

NOTICE:

Some fluid will remain in the CVT transaxle oil pan sub-assembly. Remove all bolts and carefully remove the CVT transaxle oil pan sub-assembly.

(f) Temporarily install the gasket and filler plug to the continuously variable transmission transaxle assembly.

HINT:

Reuse the old gasket, as the filler plug will need to be removed again to adjust the fluid level.

4. REMOVE OIL CLEANER MAGNET (CVT)

(a) Remove the 2 oil cleaner magnets (CVT) from the CVT transaxle oil pan sub-assembly.

*1

Oil Cleaner Magnet (CVT)

(b) Remove the metal particles adhering to the 2 oil cleaner magnets (CVT).

(c) Clean the CVT transaxle oil pan sub-assembly and remove metal particles, deposits, etc.