K114 Continuously Variable Transmission

Installation

~2min read
010203040507.56N·mlb·ft
Tightening torque found on this page

INSTALLATION

PROCEDURE

1. INSTALL OIL CLEANER MAGNET (CVT)

(a) Install the 2 oil cleaner magnets (CVT) to the CVT transaxle oil pan sub-assembly.

*1

Oil Cleaner Magnet (CVT)

2. INSTALL CVT TRANSAXLE OIL PAN SUB-ASSEMBLY

(a) Clean the mating surface of the CVT transaxle oil pan sub-assembly and the CVT transaxle assembly.

(b) Install a new CVT transaxle oil pan gasket onto the CVT transaxle oil pan sub-assembly.

(c) Install the CVT transaxle oil pan sub-assembly onto the CVT transaxle assembly using the 19 bolts.

Torque:

7.5 N·m {76 kgf·cm, 66 in·lbf}

(d) Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler pipe onto the CVT transaxle oil pan sub-assembly.

Torque:

1.7 N·m {17 kgf·cm, 15 in·lbf}

(e) Using a 6 mm hexagon socket wrench, temporarily install the gasket and overflow plug onto the CVT transaxle oil pan sub-assembly.

HINT:

Reuse the old gasket, as the overflow plug will need to be removed again to adjust the fluid level.

(f) Using a 10 mm hexagon socket wrench, install a new gasket and the drain plug onto the CVT transaxle oil pan sub-assembly.

Torque:

49 N·m {500 kgf·cm, 36 ft·lbf}

3. ADD CVT FLUID

Click here

4. CHECK FOR FLUID LEAKS

5. INSTALL ENGINE UNDER COVER REAR LH

Click here

6. INSTALL ENGINE UNDER COVER SUB-ASSEMBLY NO. 1

Click here