K114 Continuously Variable Transmission

Removal

~2min read

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) that must be performed once parts have been removed, installed or replaced during oil cooler removal/installation are shown below.

Procedure Required After Replacing / Removing / Installing Parts

Replacement part or procedure

Required Procedure

Effect/Inoperative function when procedure not performed

Link

CVT Fluid Replacement

ATF Thermal Degradation Estimate Reset

The value of the "ATF Thermal Degradation Estimate" Data List item is not estimated correctly.

PROCEDURE

1. REMOVE NO. 1 ENGINE UNDER COVER

Click here

2. REMOVE REAR LEFT ENGINE UNDER COVER

Click here

3. DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID

Click here

4. DRAIN ENGINE COOLANT

Click here

5. REMOVE NO. 2 ROCKER COVER

Click here

6. REMOVE RADIATOR COVER

Click here

7. REMOVE AIR CLEANER INLET NO. 1

Click here

8. REMOVE AIR CLEANER COVER WITH AIR CLEANER HOSE

Click here

9. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Click here

10. DISCONNECT NO. 3 WATER BYPASS HOSE

(a) Slide the clip and disconnect the water bypass hose No. 3 from the oil cooler.

*1

No. 3 water bypass hose

11. DISCONNECT NO. 5 WATER BYPASS HOSE

(a) Slide the clip and disconnect the No. 5 water bypass hose from the oil cooler.

*1

No. 5 water bypass hose

12. DISCONNECT NO. 1 TRANSMISSION OIL COOLER HOSE

(a) Slide the clip and disconnect the No. 1 transmission oil cooler hose from the oil cooler.

*1

No. 1 transmission oil cooler hose

13. DISCONNECT NO. 2 TRANSMISSION OIL COOLER HOSE

(a) Slide the clip and disconnect the No. 2 transmission oil cooler hose from the oil cooler.

*1

No. 2 transmission oil cooler hose

14. REMOVE OIL COOLER

(a) Remove the 2 bolts and the oil cooler from the transmission oil cooler bracket.

15. REMOVE TRANSMISSION OIL COOLER BRACKET

(a) Remove the 3 bolts and the transmission oil cooler bracket from the continuously variable transaxle assembly.