Introduction

General Information

~3min read
010203040503022N·mlb·ft
Tightening torque found on this page

GENERAL INFORMATION

GENERAL DESCRIPTION

(a) Repair operations can be mainly divided into the following 3 procedures:

(1) Diagnosis.

(2) Removal/installation, replacement, disassembly/reassembly, inspection and adjustment.

(3) Final inspection.

(b) The following procedures are not included in this manual. However, they must be performed.

(1) Use a jack or lifting device to perform these operations.

(2) Clean all removed parts.

(3) Perform a visual inspection before and after starting work.

PREPARATION

(a) Depending on the nature of the repair, the use of special service tools (SST) or special service materials (SSM) may be essential. Be sure to use SST and SSM when necessary and follow the work procedure correctly. The "Preparation" section of this manual lists the SST and SSM.

REPAIR PROCEDURES

(a) An illustration of the component parts is added under the title if necessary.

(b) Non-reusable parts, grease application points, pre-coated parts and specified torque values are shown in the component illustrations.

  • The following illustration is an example.

Symbol

Content

Torque for "Main Areas Related to Basic Vehicle Performance" such as Driving/Turning/Stopping: N*m (kgf*cm, lbf*ft)

N*m (kgf*cm, lbf*in): Specified torque

●

Non-reusable part

★

Pre-coated part

Apply lubricant here.

Do not apply lubricant to threaded parts.

CAUTION:

"Main areas related to basic vehicle performance" such as driving/turning/stopping indicate the areas that require a higher degree of tightening precision.

*A

Example

-

-

*1

CYLINDER BOOT

*2

PISTON SEAL

*3

FRONT DISC BRAKE PISTON

*4

FRONT DISC BRAKE BLEEDER PLUG

*5

FRONT DISC BRAKE BLEEDER PLUG CAP

*6

MOUNTING RING

*7

LH DISC BRAKE CYLINDER ASSEMBLY

-

-

Torque for "Main Areas Related to Basic Vehicle Performance" such as Driving/Turning/Stopping: N*m (kgf*cm, lbf*ft)

N*m (kgf*cm, lbf*in): Specified torque

●

Non-reusable part

Lithium soap base glycol grease

(c) Tightening torques, grease application points and non-reusable parts are highlighted in the procedures.

HINT:

In some cases, this information can only be provided in the form of an illustration. Torque, lubricant and other information is then given in the illustration.

(d) Only important items are described in the text. Operations to be performed and other information are shown in the illustrations next to the text. Standard values and remarks supplement the text and illustrations.

Diagram

Operation to perform and location of operation

Title

Operation to Perform

Explanatory text

  • Work Procedure
  • Certain information, such as specifications and warnings, is shown in bold.

(e) In some cases, diagrams apply to several similar models. Some specific details may therefore differ on the actual vehicle.

(f) Procedures are presented as step-by-step instructions.

MAINTENANCE SPECIFICATIONS

(a) Throughout this manual, specifications are printed in bold. They are also listed in the "Specifications" section of this manual.

TERMINOLOGY

WARNING

Indicates the possibility of injury.

NOTICE

Indicates the possibility of damage to the components being repaired.

HINT

Provides additional information to help the technician perform repairs.

INTERNATIONAL UNITS OF MEASUREMENT

(a) The units used in this manual conform to international units of measurement. Other units from the metric system and the imperial (US customary) system are also given.

  • Example:

Torque:

30 N·m {306 kgf·cm, 22 ft·lbf}