Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL NO. 2 STEERING RACK BOOT
(a) Apply lithium soap base glycol grease inside the small end of a new No. 2 steering rack boot. |
![]() |
(b) Install the No. 2 steering rack boot into the groove on the rack housing.
NOTICE:
- Be careful not to damage or twist the No. 2 steering rack boot.
- Make sure that the No. 2 steering rack boot is free of rust and foreign matter.
2. INSTALL NO. 1 STEERING RACK BOOT
HINT:
Perform the same procedure as for the No. 2 steering rack boot.
3. INSTALL STEERING RACK BOOT CLAMP (for Left Side)
(a) Using the SST, install a new steering rack boot clamp as shown in the illustration. SST: 09521-24010 Clearance: 3.0 mm (0.118 in.) maximum NOTICE: Be careful not to damage the No. 2 steering rack boot. |
![]() |
4. INSTALL STEERING RACK BOOT CLAMP (for Right Side)
HINT:
Perform the same procedure as for the left side.
5. INSTALL STEERING RACK BOOT CLIP (for Left Side)
(a) Using pliers, install the steering rack boot clip.
6. INSTALL STEERING RACK BOOT CLIP (for Right Side)
HINT:
Perform the same procedure as for the left side.
7. INSPECT STEERING GEAR HOUSING ASSEMBLY
(a) Using the SST, turn the pinion shaft and check that the left and right steering rack boots expand and contract smoothly. SST: 09616-00020 If the left and right steering rack boots do not expand and contract evenly, use new steering rack boot retainers and reinstall the steering rack boots. |
![]() |


