Wiper / Washer

Installation

~2min read

INSTALLATION

PROCEDURE

1. INSTALL RAIN SENSOR ADHESIVE TAPE

HINT:

The rain sensor adhesive tape is reusable. Replace the adhesive tape only if it is damaged or contaminated with foreign matter.

(a) Remove the rain sensor adhesive tape.

(b) Clean the sensitive part of the rain sensor with a cloth, etc.

(c) Remove the smaller protective sheet, then attach the rain sensor adhesive tape to the sensitive part as shown in the illustration.

HINT:

Use your fingers to remove any air bubbles trapped under the adhesive tape.

Standard clearance

Area

Measurement

A

14.4 mm (0.567 in.)

B

7.25 mm (0.285 in.)

2. INSTALL RAIN SENSOR

(a) Clean the windshield with a cloth.

NOTICE:

  • Make sure no traces of rain sensor adhesive tape remain on the windshield. If there are, remove them.
  • If traces of rain sensor adhesive tape remain on the windshield, replace the tape.

(b) When installing a new rain sensor or if the rain sensor adhesive tape has been replaced:

(1) Remove the protective sheet.

HINT:

Do not touch the silicone surface.

(c) Connect the connector.

(d) Slowly slide the rain sensor across the surface of the windshield glass, as shown in the illustration, to prevent air bubbles from collecting.

*a

Stopper

Lock

Install in this direction

HINT:

Do not touch the silicone surfaces or the glass surfaces.

(e) Press in the stopper to reinstall the rain sensor as shown in the illustration.

3. REINSTALL RAIN SENSOR COVER

(a) Engage the guide and claws to reinstall the rain sensor cover.