Wiper / Washer

Inspection On Vehicle

~1min read

INSPECTION ON VEHICLE

PROCEDURE

1. INSPECT RAIN SENSOR

(a) Disconnect the R1 connector from the rain sensor.

*a

Front view of wire harness side connector

(to rain sensor)

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:

Tester Connection

Condition

Specified Condition

R1-4 (SIG) - R1-2 (ES)

Ignition Switch in ON position

11 à 14 V

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

R1-2 (ES) - Body ground

Always

Below 1 Ω

If the result is not as specified, repair or replace the wire harness or connector.

(d) Reconnect the R1 connector to the rain sensor.

*a

Component with Wire Harness Connected

(Rain Sensor)

(e) Connect an oscilloscope to the rain sensor connector.

(f) Check for pulses.

OK:

Tester Connection

Condition

Specified Condition

3 (MPX) - 2 (ES)

Ignition Switch in ON position

Pulse generation

If the result is not as specified, replace the rain sensor.