Brake System (Other)

Installation

~2min read
0102030405012.79N·mlb·ft
Tightening torque found on this page

INSTALLATION

PROCEDURE

1. INSTALL BRAKE PEDAL PAD

(a) Install the brake pedal pad to the brake pedal support assembly.

2. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY

(a) Install the nut to the brake pedal support assembly.

(b) Temporarily install the brake pedal support assembly using 2 new clips.

(c) Install the 4 nuts.

Torque:

12.7 N·m {130 kgf·cm, 9 ft·lbf}

NOTICE:

Tighten the nuts in the order shown in the illustration.

(d) Install the brake pedal support assembly to the instrument panel reinforcement assembly using the bolt.

Torque:

24 N·m {241 kgf·cm, 17 ft·lbf}

(e) With brake pedal depressed force sensor switch:

(1) Engage the clamp to install the wire harness to the brake pedal support assembly.

(2) Connect the brake pedal depressed force sensor switch connector.

3. INSTALL PUSH ROD PIN

(a) Apply lithium soap base glycol grease to the push rod pin.

Lithium soap base glycol grease

(b) Connect the brake master cylinder push rod clevis to the brake pedal support assembly using the push rod pin, and install a new clip as shown in the illustration.

NOTICE:

Make sure to install the push rod pin in the correct direction.

4. INSTALL BRAKE PEDAL RETURN SPRING

(a) Install the brake pedal return spring between the brake pedal support assembly and the push rod pin.

5. INSTALL STOP LIGHT SWITCH ASSEMBLY ADJUSTING FIXTURE

6. INSTALL STOP LIGHT SWITCH ASSEMBLY

Click here

7. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Click here

8. INSPECT AND ADJUST BRAKE PEDAL

Click here