Installation
INSTALLATION
PROCEDURE
1. INSTALL HORN BUTTON ASSEMBLY
(a) Make sure the ignition switch is in the OFF position.
(b) Make sure the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) for single type:
(1) Install the wire harness clamp. |
|
(2) Connect the airbag connector to the horn button assembly.
NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.
(3) Push the airbag connector lock to install the airbag connector.
NOTICE:
Make sure the airbag connector lock is locked securely.
(4) Connect the horn connector to the horn button assembly.
(d) for double type:
(1) Install the wire harness clamp. |
|
(2) Connect the 2 airbag connectors to the horn button assembly.
NOTICE:
- When connecting any airbag connector, take care not to damage the airbag wire harness.
- Make sure to connect each connector to its matching color.
(3) Push in the 2 airbag connector locks to reconnect the 2 airbag connectors.
NOTICE:
Make sure the airbag connector lock is locked securely.
(4) Connect the horn connector to the horn button assembly.
(e) Press the horn button assembly to fully engage the claws, and install the horn button assembly. NOTICE:
|
![]() |
2. CONNECT THE CABLE TO THE NEGATIVE BATTERY TERMINAL
Click here![]()
NOTICE:
When the cable has been disconnected, some systems must be reset after the cable is reconnected.
Click here
![]()
3. INSPECT HORN BUTTON ASSEMBLY
(a) Check that the horn sounds.
If the horn does not sound, inspect the horn system.
Click here![]()
4. PERFORM DIAGNOSTIC SYSTEM CHECK
Click here![]()
5. CHECK SRS WARNING LIGHT
Click here![]()


