Door Lock

Inspection

~3min read

INSPECTION

PROCEDURE

1. INSPECT ELECTRONIC KEY TRANSMITTER SUBASSEMBLY

(a) Check the operation of the electronic key transmitter subassembly.

(1) Remove the transmitter battery from the electronic key transmitter subassembly.

Click here

(2) Install a new or good transmitter battery.

Click here

NOTICE:

When replacing the transmitter battery, before starting work, discharge static electricity built up in the body by touching the vehicle, for example, to avoid damaging the electronic key transmitter subassembly.

HINT:

If a new battery or a good transmitter battery is not available, connect 2 new 1.5 V batteries in series. Then connect the wires to the batteries and apply 3 V to the electronic key transmitter subassembly as shown in the illustration.

(3) Outside the vehicle, stand approximately 1 m (3.28 ft) from the driver door outside handle, point the key toward the vehicle and press one of the switches on the transmitter subassembly to test it.

OK:

Door locking can be performed using the electronic key transmitter subassembly.

The LED turns on more than once.

  • The operating range depends on the user, their location and the orientation of the electronic key transmitter subassembly.
  • Weak radio waves to the electronic key transmitter subassembly may be affected if there are strong radio waves or noise in this area. The operating range of the electronic key transmitter subassembly may be reduced, or the electronic key transmitter subassembly may not function.

(b) Check the battery capacity.

(1) Remove the transmitter battery from the malfunctioning electronic key transmitter subassembly. Attach a conductive wire (0.6 mm (0.0236 in.) diameter max., including insulation) to the negative terminal using tape or similar.

Click here

NOTICE:

Do not wrap the conductive wire around a terminal, wedge it between terminals or solder it. A terminal may be deformed or damaged, and the transmitter battery will not be installed correctly.

(2) Carefully pull the conductive wire out of the position shown in the illustration, and reinstall the previously removed transmitter battery.

NOTICE:

When replacing the transmitter battery, before starting work, discharge static electricity built up in the body by touching the vehicle, for example, to avoid damaging the electronic key transmitter subassembly.

(3) Check the transmitter battery voltage.

HINT:

  • When measuring the transmitter battery voltage, with the door handle lock sensor activated, bring the electronic key transmitter subassembly into the unlock operating range to perform the measurement. For the unlock operating range, refer to the system description.

    Click here

  • Perform the measurement when the key is at room temperature.
  • When transmitting, the key sends voltage information to the certification ECU (smart key ECU assembly). When this voltage is 2.1 V or less, the "Key Low Battery" item in the Data List displays "Yes".

Standard voltage:

Tester Connection

Condition

Specified Condition

Positive (+) terminal of transmitter battery - negative (-) terminal of transmitter battery

Engine switch OFF, all doors closed and door lock sensor selected

2,5 à 3,2 V

If the result is not as specified, replace the transmitter battery.

*a

GND