Inspection
INSPECTION
PROCEDURE
1. INSPECT DOOR CONTROL TRANSMITTER
(a) Check the operation of the door control transmitter assembly.
(1) Remove the transmitter battery from the door control transmitter assembly.
Click here![]()
(2) Install a new or fully charged transmitter battery.
Click here![]()
NOTICE:
When replacing the transmitter battery, before starting work, discharge any static electricity built up in the body, for example by touching the vehicle, to prevent damage to the door control transmitter assembly.
HINT:
If no new or fully charged transmitter battery is available, first connect 2 new 1.5 V batteries in series. Then connect the wires to the batteries and apply 3 V to the door control transmitter assembly as shown in the illustration.
(3) Outside the vehicle, stand approximately 1 m (3.28 ft) from the outside handle of the driver's door, and test the door control transmitter assembly by pointing the key toward the vehicle and pressing a door control transmitter assembly switch.
OK:
The door lock can be operated using the door control transmitter assembly.
- The operating range depends on the user, the orientation of the door control transmitter assembly and the user's location.
- Weak radio waves from the door control transmitter assembly may be affected if there are strong radio waves or electrical noise in this area. The operating range of the door control transmitter assembly may be reduced, or the door control transmitter assembly may not function.
(b) Check the battery capacity.
(1) Remove the transmitter battery from the malfunctioning door control transmitter assembly. Attach a conductive wire (0.6 mm (0.0236 in.) diameter max., including insulation) to the negative terminal using tape or similar.
Click here![]()
NOTICE:
Do not wrap the conductive wire around a terminal, wedge it between terminals or solder it. A terminal may be deformed or damaged, and the transmitter battery will not be installed correctly.
(2) Carefully pull the conductive wire out of the position shown in the illustration, and reinstall the previously removed transmitter battery. NOTICE: When replacing the transmitter battery, before starting work, discharge any static electricity built up in the body, for example by touching the vehicle, to prevent damage to the door control transmitter assembly. |
![]() |
(3) Check the transmitter battery voltage. HINT: Measure the transmitter battery voltage while pressing the lock or unlock switch of the door control transmitter assembly. Standard voltage:
If the result is not as specified, replace the transmitter battery. |
![]() |

