Rear wheel alignment

ADJUSTMENT

1. 1
   INSPECT TIRE
2. 2
   MEASURE VEHICLE HEIGHT

NOTICE: Before inspecting wheel alignment, adjust the vehicle height to the specified value. 3. INSPECT TOE−IN

HINT:

• Measure ”A + B” when ”C − D” cannot be measured.

• If toe−in is not within the specified range, adjust No.2 lower suspension arms.

4. ADJUST TOE−IN a. Measure the lengths of the right and left No.2 lower suspension arms.No.2 lower suspension arm length difference: 1.5 mm (0.06 in.) or less

If the left−right difference is larger than 1.5 mm (0.06 in.), adjust it by following the procedures below.

1. 1

   Loosen the 2 lock nuts.

2. 2

   Turn the right and left adjusting tubes by an equal amount to adjust toe−in.

HINT:

• Try to adjust toe−in to the center value.

• One turn of each adjusting tube will adjust toe−in by approximately 1.2 (1 12’), 10.8 mm (0.425 in.).

d. Torque the 2 lock nuts.Torque: 56 N·m

5. INSPECT CAMBER

HINT: Camber is not adjustable. If the measurement is not within the specification, inspect the suspension parts for damage and/or wear, and replace them if necessary.