Antenna Coil Open / Short (B2784)
DESCRIPTION
When an open or short circuit is detected in the antenna coil built into the transponder key coil, the transponder key ECU assembly stores this DTC.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
B2784 |
Antenna Coil Open / Short |
The antenna coil in the transponder key coil is open/shorted. |
|
DTC Output Confirmation Operation:
|
Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
Engine cannot be started |
- |
DTC No. | Data List and Active Test |
|---|---|
B2784 |
Antenna Coil Status |
WIRING DIAGRAM
NOTICE:
- If the transponder key ECU assembly is replaced, refer to Registration.
Click here
.gif)
- After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
PROCEDURE
CHECK CONNECTION OF CONNECTOR
(a) Check that the connector is properly connected to the transponder key coil.
|
CLEAR DTC
(a) Clear the DTCs.
Body Electrical > Immobiliser > Clear DTCs
|
CHECK FOR DTC
(a) Perform "DTC Output Confirmation Operation" procedure.
(b) Check for DTCs.
Body Electrical > Immobiliser > Trouble CodesOK:
DTC B2784 is not output.
Result | Proceed to |
|---|---|
B2784 is not output |
A |
B2784 is output |
B |
| A | END (CONNECTOR WAS NOT CONNECTED PROPERLY) |
|
CHECK TRANSPONDER KEY COIL (OUTPUT)
(a) Disconnect the transponder key coil connector.
(b) Using an oscilloscope, check the waveform.
*a |
Front view of wire harness connector (to Transponder Key Coil) |
*b |
Waveform 1 |
*c |
Waveform 2 |
- |
- |
Tester Connection | Condition | Tool Setting | Specified Condition |
|---|---|---|---|
I64-1 (ANT1) - Body ground |
Within 3 seconds of inserting door control transmitter assembly into ignition key cylinder |
20 V/DIV., 2 s./DIV. |
Pulse generation (See waveform 1) |
I64-5 (ANT2) - Body ground |
Within 3 seconds of inserting door control transmitter assembly into ignition key cylinder |
20 V/DIV., 2 s./DIV. |
Pulse generation (See waveform 2) |
OK:
Waveform is similar to that shown in the illustration.
| OK | REPLACE TRANSPONDER KEY COIL |
|
CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU ASSEMBLY - TRANSPONDER KEY COIL)
(a) Disconnect the I67 transponder key ECU assembly connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
I67-2 (ANT1) - I64-1 (ANT1) |
Always |
Below 1 Ω |
I67-3 (ANT2) - I64-5 (ANT2) |
Always |
Below 1 Ω |
I67-2 (ANT1) or I64-1 (ANT1) - Other terminals and body ground |
Always |
10 kΩ or higher |
I67-3 (ANT2) or I64-5 (ANT2) - Other terminals and body ground |
Always |
10 kΩ or higher |
| OK | REPLACE TRANSPONDER KEY ECU ASSEMBLY |
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |