Vehicle Interior
Transponder Chip Malfunction (B2793,B2797)
In this manual: Vehicle Interior
~1min read
DESCRIPTION
- DTC B2793 is stored when a malfunction is found in the door control transmitter assembly during key ID code registration or a key ID code is not registered normally. Replace the door control transmitter assembly if key ID code registration cannot be performed normally and this DTC is output.
- DTC B2797 is stored when a door control transmitter assembly with a BCC malfunction is inserted into the ignition key cylinder.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
B2793 |
Transponder Chip Malfunction |
A transponder chip malfunction (1 trip detection logic*). |
Door control transmitter assembly |
DTC Output Confirmation Operation:
|
B2797 |
Communication Malfunction No. 1 |
A door control transmitter assembly with a BCC malfunction is inserted into the ignition key cylinder (1 trip detection logic*). |
Door control transmitter assembly |
DTC Output Confirmation Operation:
|
- *: Only output while a malfunction is present.
Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
Engine cannot be started |
- |
DTC No. | Data List and Active Test |
|---|---|
B2793 |
- |
B2797 |
- |
NOTICE:
- If the door control transmitter assembly is replaced, refer to Registration.
Click here
.gif)
- After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
PROCEDURE
REPLACE DOOR CONTROL TRANSMITTER ASSEMBLY
(a) Replace the door control transmitter assembly.
| NEXT | END (DOOR CONTROL TRANSMITTER ASSEMBLY WAS DEFECTIVE) |
Was this page helpful?