Unmatched Key Code (B2795)
DESCRIPTION
This DTC is stored when a door control transmitter assembly with a different vehicle serial number is inserted into the ignition key cylinder.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
B2795 |
Unmatched Key Code |
A door control transmitter assembly with a different vehicle serial number is inserted into the ignition key cylinder (1 trip detection logic*). |
|
DTC Output Confirmation Operation:
|
- *: Only output while a malfunction is present.
Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
Engine cannot be started |
- |
DTC No. | Data List and Active Test |
|---|---|
B2795 |
- |
NOTICE:
- If the transponder key ECU assembly or a door control transmitter assembly is replaced, refer to Registration.
Click here
.gif)
- After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
PROCEDURE
CLEAR DTC
(a) Clear the DTCs.
Body Electrical > Immobiliser > Clear DTCs
|
CHECK FOR DTC
(a) Perform "DTC Output Confirmation Operation" procedure.
(b) Check for DTCs.
Body Electrical > Immobiliser > Trouble CodesHINT:
If DTC B2795 is stored, check for DTCs with the next door control transmitter assembly after clearing the DTCs.
OK:
DTC B2795 is not output.
Result | Proceed to |
|---|---|
B2795 is not output |
A |
DTC B2795 is output for all of the door control transmitter assemblies |
B |
DTC B2795 is output for any of the door control transmitter assemblies |
C |
| A | USE SIMULATION METHOD TO CHECK |
| B | REPLACE TRANSPONDER KEY ECU ASSEMBLY |
|
CHECK OPERATION (IG ON)
(a) Check that the ignition switch can be turned to ON using the door control transmitter assembly for which the DTC was stored.
OK:
Ignition switch can be turned to ON using the door control transmitter assembly (for which the DTC was stored).
| NG | REPLACE DOOR CONTROL TRANSMITTER ASSEMBLY THAT DTC IS OUTPUT |
|
REREGISTRATION
(a) Clear the DTCs.
Body Electrical > Immobiliser > Clear DTCs(b) Reregister the key ID code with the transponder key ECU assembly.
OK:
Registration procedure can be completed.
| OK | END (DOOR CONTROL TRANSMITTER ASSEMBLY REGISTRATION FAILURE) |
| NG | REPLACE DOOR CONTROL TRANSMITTER ASSEMBLY |