Front Wiper Motor Circuit
DESCRIPTION
The windshield wiper relay assembly controls the windshield wiper motor assembly through this circuit.
WIRING DIAGRAM
PROCEDURE
PERFORM ACTIVE TEST USING GTS (FRONT WIPER LO OPERATION / FRONT WIPER HI OPERATION)
(a) Perform the Active Test according to the display on the GTS.
Body Electrical > Main Body > Active TestTester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
Front Wiper Lo Operation |
Function to operate the windshield wiper motor assembly in LO |
OFF or ON |
- |
Front Wiper Hi Operation |
Function to operate the windshield wiper motor assembly in HI |
OFF or ON |
- |
Front Wiper Lo Operation
Body Electrical > Main Body > Active TestFront Wiper Hi Operation
OK:
Windshield wiper motor assembly operates normally.
| OK | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
|
INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY
Click here ![]()
| NG | REPLACE WINDSHIELD WIPER MOTOR ASSEMBLY |
|
CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER RELAY ASSEMBLY - WINDSHIELD WIPER MOTOR ASSEMBLY)
(a) Disconnect the A55 and A56 windshield wiper relay assembly connectors.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
A55-2 (+1) - A31-5 (+1) |
Always |
Below 1 Ω |
A55-4 (+2) - A31-3 (+2) |
Always |
Below 1 Ω |
A56-6 (+SM) - A31-1 (+S) |
Always |
Below 1 Ω |
A55-2 (+1) or A31-5 (+1) - Body ground |
Always |
10 kΩ or higher |
A55-4 (+2) or A31-3 (+2) - Body ground |
Always |
10 kΩ or higher |
A56-6 (+SM) or A31-1 (+S) - Body ground |
Always |
10 kΩ or higher |
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER MOTOR ASSEMBLY - BODY GROUND)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
|---|---|---|
A31-4 (E) - Body ground |
Always |
Below 1 Ω |
| OK | REPLACE WINDSHIELD WIPER RELAY ASSEMBLY |
| NG | REPAIR OR REPLACE HARNESS OR CONNECTOR |