How To Proceed With Troubleshooting
HINT:
- Use the following procedure to troubleshoot the continuously variable transaxle system.
- *: Use the GTS.
PROCEDURE
VEHICLE BROUGHT TO WORKSHOP
|
CUSTOMER PROBLEM ANALYSIS
(a) Refer to How to Troubleshoot ECU Controlled Systems in Introduction.
Click here ![]()
|
INSPECT AUXILIARY BATTERY VOLTAGE
(a) Measure the auxiliary battery voltage.
Standard Voltage:
11 to 14 V
HINT:
If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.
|
CHECK CAN COMMUNICATION SYSTEM*
(a) Using the GTS, check if the CAN communication system is functioning normally.
CAN Bus CheckOK:
CAN communication system is functioning normally.
HINT:
- Refer to CAN Bus Check in CAN Communication System.
Click here
.gif)
- The TCM is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there are no malfunctions in the CAN communications system.
| NG | GO TO CAN COMMUNICATION SYSTEM |
|
CHECK AND CLEAR DTCS AND FREEZE FRAME DATA*
(a) Refer to DTC Check/Clear.
Click here
![]()
|
SELECT CHECK MODE DIAGNOSIS*
(a) Refer to Check Mode Procedure.
Click here ![]()
|
CHECK FOR DTC*
(a) Proceed to DTC Check/Clear.
Click here
![]()
Result | Proceed to |
|---|---|
DTCs are not output. |
A |
DTCs are output. |
B |
| B | GO TO STEP 14 |
|
BASIC INSPECTION
(a) Refer to Continuously Variable Transaxle Fluid.
Click here ![]()
(b) Refer to Park/Neutral Position Switch.
Click here ![]()
(c) Refer to Shift Lever.
Click here ![]()
| NG | GO TO STEP 11 |
|
PROBLEM SYMPTOMS CONFIRMATION
(a) Refer to Road Test.
Click here ![]()
(b) Refer to Mechanical System Tests.
Click here ![]()
(c) Refer to Hydraulic Test.
Click here ![]()
Result | Proceed to |
|---|---|
Symptom does not occur |
A |
Symptom occurs |
B |
| B | GO TO STEP 11 |
|
SYMPTOM SIMULATION
(a) Refer to Symptom Simulation.
Click here ![]()
|
COMPONENT INSPECTION
|
REPAIR OR REPLACE
|
CONFIRMATION TEST
| NEXT | END |
DIAGNOSTIC TROUBLE CODE CHART
(a) Proceed to Diagnostic Trouble Code Chart.
|
CIRCUIT INSPECTION
|
IDENTIFICATION OF PROBLEM
|
REPAIR OR REPLACE
|
CONFIRMATION TEST
| NEXT | END |