Vehicle Exterior
Inspection
INSPECTION
PROCEDURE
1. INSPECT BACK DOOR OPENER SWITCH ASSEMBLY (w/ Smart Key System)
(a) Check the operation of the opener switch.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
U5-3 (UL) - U5-2 (E) |
Back door opener switch pushed (ON) |
Below 1 Ω |
U5-3 (UL) - U5-2 (E) |
Back door opener switch not pushed (OFF) |
10 kΩ or higher |
If the result is not as specified, replace the back door opener switch assembly. |
 |
*a |
Not Pushed (OFF) |
*b |
Pushed (ON) |
*c |
Component without harness connected
(Back Door Opener Switch Assembly) |
|
|
(b) Check the operation of the back door lock switch.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
U5-1 (L) - U5-2 (E) |
Back door lock switch pushed (ON) |
Below 1 Ω |
U5-1 (L) - U5-2 (E) |
Back door lock switch not pushed (OFF) |
10 kΩ or higher |
If the result is not as specified, replace the back door opener switch assembly. |
 |
*a |
Not Pushed (OFF) |
*b |
Pushed (ON) |
*c |
Component without harness connected
(Back Door Opener Switch Assembly) |
|
|
2. INSPECT BACK DOOR OPENER SWITCH ASSEMBLY (w/o Smart Key System)
(a) Check the operation of the opener switch.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
U5-3 (UL) - U5-2 (E) |
Back door opener switch pushed (ON) |
Below 1 Ω |
U5-3 (UL) - U5-2 (E) |
Back door opener switch not pushed (OFF) |
10 kΩ or higher |
If the result is not as specified, replace the back door opener switch assembly. |
 |
*a |
Not Pushed (OFF) |
*b |
Pushed (ON) |
*c |
Component without harness connected
(Back Door Opener Switch Assembly) |
|
|
Was this page helpful?