M20a-fks Drive Belt
Removal
REMOVAL
COMPONENTS (REMOVAL)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
REAR ENGINE UNDER COVER RH |
51443C |
- |
- |
- |
2 |
V-RIBBED BELT |
16361A |
- |
- |
|
PROCEDURE
1. REMOVE REAR ENGINE UNDER COVER RH
2. REMOVE V-RIBBED BELT
(1) Release the V-ribbed belt tension by turning the V-ribbed belt tensioner assembly counterclockwise.
(2) Turn the V-ribbed belt tensioner assembly counterclockwise to align its holes, and then insert a 5 mm hexagon wrench to secure the V-ribbed belt tensioner assembly.
(3) Remove the V-ribbed belt.
Installation
INSTALLATION
COMPONENTS (INSTALLATION)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
V-RIBBED BELT |
16361A |
- |
- |
|
2 |
REAR ENGINE UNDER COVER RH |
51443C |
- |
- |
- |
PROCEDURE
1. INSTALL V-RIBBED BELT
![]() |
HINT: When reusing the V-ribbed belt, check the ribs and back of the V-ribbed belt for wear and cracks. If wear or a crack that reaches the core (at more than 1 point) is found, replace the V-ribbed belt. |
*1 |
Crankshaft Pulley Assembly |
*2 |
Generator Assembly |
*3 |
Compressor Assembly with Pulley |
- |
- |
*a |
Correct |
*b |
Incorrect |
(1) Set the V-ribbed belt onto each pulley as shown in the illustration.
(2) Turn the V-ribbed belt tensioner assembly clockwise and remove the 5 mm hexagon wrench.
(3) After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the V-ribbed belt has not slipped out of the grooves on the bottom of the pulley by hand.
2. INSTALL REAR ENGINE UNDER COVER RH
.png)
.png)
.png)
.gif)
.png)
.png)
.png)
.gif)