Pb10 Hybrid Transaxle Fluid
Components
COMPONENTS
ILLUSTRATION
*1 |
NO. 1 ENGINE UNDER COVER ASSEMBLY |
*2 |
FILLER PLUG |
*3 |
DRAIN PLUG |
*4 |
GASKET |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
Replacement
REPLACEMENT
PROCEDURE
1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
Click here ![]()
2. REPLACE HYBRID TRANSAXLE FLUID
(a) Lift the vehicle. [#1]
NOTICE:
Set the vehicle on a lift so that the vehicle is kept level when it is lifted up (make sure that the tilt angle from the front to rear of the vehicle is within +/- 1°).
(b) Remove the filler plug and gasket from the hybrid vehicle transaxle assembly. [#2] |
![]() |
(c) Remove the drain plug and gasket from the hybrid vehicle transaxle assembly and drain the hybrid transaxle fluid. [#3] |
![]() |
(d) Temporarily install the drain plug and gasket to the hybrid vehicle transaxle assembly. [#4]
HINT:
Reuse the old gasket as the drain plug will be removed again.
(e) Add hybrid transaxle fluid until the hybrid transaxle fluid level is between 0 to 10 mm (0 to 0.394 in.) from the bottom lip of the filler plug opening. [#5] NOTICE:
|
|
(f) Temporarily install the filler plug and gasket to the hybrid vehicle transaxle assembly. [#6]
HINT:
Reuse the old gasket as the filler plug will be removed again.
(g) Lower the vehicle. [#7]
(h) Put the engine in maintenance mode. [#8]
Click here ![]()
(i) Idle the engine for 30 seconds with the ignition switch ON (READY). [#9]
(j) Turn the ignition switch off. [#10]
(k) Repeat steps [#1] to [#10].
(l) Repeat steps [#1] to [#3].
(m) Install the drain plug and a new gasket to the hybrid vehicle transaxle assembly.
Torque:
50 N·m {510 kgf·cm, 37 ft·lbf}
(n) Temporarily install the filler plug and gasket to the hybrid vehicle transaxle assembly.
HINT:
Reuse the old gasket as the filler plug will be removed again.
3. ADD HYBRID TRANSAXLE FLUID
Click here ![]()
4. INSPECT HYBRID TRANSAXLE FLUID
Click here ![]()
5. INSPECT FOR HYBRID TRANSAXLE FLUID LEAK
6. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
Click here ![]()
.png)


