Vehicle Exterior
On-vehicle Inspection
In this manual: Vehicle Exterior
~1min read
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT HOOD SUB-ASSEMBLY
(a) Check that the clearance measurements of areas A through G are within each standard range.
Standard Clearance Area | Measurement | Area | Measurement |
|---|---|---|---|
A |
3.0 to 6.0 mm (0.1181 to 0.2362 in.) |
B |
-1.5 to 1.5 mm (-0.0591 to 0.0591 in.) |
C |
3.5 to 6.5 mm (0.1378 to 0.2559 in.) |
D |
-1.5 to 1.5 mm (-0.0591 to 0.0591 in.) |
E |
8.3 mm (0.3268 in.) |
F |
5.0 mm (0.1969 in.) |
G |
0.0 mm (0 in.) |
- |
- |
Was this page helpful?