Removal
REMOVAL
COMPONENTS (REMOVAL)
Procedure | Part Name Code | ![]() | ![]() | ![]() |
|
|---|---|---|---|---|---|
1 |
BLOWER ASSEMBLY |
87130D |
- |
- |
- |
2 |
AIR CONDITIONING HARNESS ASSEMBLY |
82210K |
- |
- |
- |
3 |
NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY |
87050C |
- |
- |
- |
4 |
HEATER PIPE GROMMET |
88897M |
- |
- |
- |
5 |
HEATER CLAMP |
87124B |
- |
- |
- |
6 |
HEATER RADIATOR UNIT SUB-ASSEMBLY |
87107A |
- |
- |
- |
7 |
COOLER PIPE GROMMET |
88897K |
- |
- |
- |
8 |
COOLER EXPANSION VALVE |
88515 |
- |
- |
|
9 |
NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY |
88501 |
- |
- |
|
10 |
NO. 1 COOLER THERMISTOR |
88625 |
- |
- |
- |
*1 |
UPPER HEATER CASE |
- |
- |
● |
Non-reusable part |
- |
- |
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click here ![]()
HINT:
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
- Learning completes when vehicle is driven
Effect/Inoperative Function When Necessary Procedures are not Performed
Necessary Procedures
Link
*1: for Gasoline Model Front Camera System
Drive the vehicle straight ahead at 15 km/h or more for 1 second or more.
.gif)
Stop and start system*1
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)
.gif)
- Learning completes when vehicle is operated normally
Effect/Inoperative Function When Necessary Procedures are not Performed
Necessary Procedures
Link
Power door lock control system
- Back door opener
Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.
.gif)
Power back door system
Fully close the back door by hand.
HINT:
Initialization is not necessary if the above procedures are performed while the back door is closed.
.gif)
Air conditioning system
After the ignition switch is turned to ON, the servo motor standard position is recognized.
-
PROCEDURE
1. REMOVE BLOWER ASSEMBLY
Click here ![]()
2. REMOVE AIR CONDITIONING HARNESS ASSEMBLY
Click here ![]()
3. REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
Click here ![]()
4. REMOVE HEATER PIPE GROMMET
Click here ![]()
5. REMOVE HEATER CLAMP
Click here ![]()
6. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY
Click here ![]()
7. REMOVE COOLER PIPE GROMMET
Click here ![]()
8. REMOVE COOLER EXPANSION VALVE
![]() |
Click here |
9. REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
![]() |
Click here |
10. REMOVE NO. 1 COOLER THERMISTOR

.png)
.png)
.png)