Toyota Corolla Quiz
Automatic transmission / trans

Floor shift parking lock cable assy (atm)

In this manual: Automatic transmission / trans
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
14steps
~84min
3/5difficulty
Done 0 of 14
Replacement 1. Precaution 2. Disconnect battery negative terminal 3. Place front wheels facing straight ahead 4. Remove horn button assy 5. Remove steering wheel assy

sst 09950–50013 (09951–05010, 09952–05010, 09953–05020, 09954–05021)

6. Remove steering column cover 7. Remove console panel upper 8. Remove parking brake hole cover sub–assy 9. Remove console box carpet 10. Remove console box sub–assy rear 11. Remove floor shift parking lock cable assy
Toyota Corolla. Remove floor shift parking lock cable assy
  1. Remove the cable end from the lever pin of the floor shift assembly.
    Toyota Corolla. Remove floor shift parking lock cable assy
  2. Using a screwdriver, disconnect the parking lock cable from the floor shift assembly.
    Toyota Corolla. Remove floor shift parking lock cable assy
  3. Disconnect the cable clamp.
  4. turn the ignition switch acc or on.
    Toyota Corolla. Remove floor shift parking lock cable assy
  5. Using a screwdriver, remove the cable from the upper bracket.
Hint

: before disconnecting the cable, keep in mind each of the physical relationship between the connector and wire harness or other cables

 12. Install floor shift parking lock cable assy
Toyota Corolla. Install floor shift parking lock cable assy
  1. Turn the ignition switch acc or on.
  2. install the cable to the upper bracket.
Hint

: connect the removed cable so that it will be the same physical relationship you kept in mind before its disconnection.
Toyota Corolla. Install floor shift parking lock cable assy
  1. Connect the cable clamp.
    Toyota Corolla. Install floor shift parking lock cable assy
  2. Set the accessory tool.
  3. Shift the shift lever to n position and turn the ignition switch to acc or on.
  4. Set the accessory tool to the shift lock control unit assy as shown in the illustration.

    Accessory tool parts no.: 33693–02010

    Toyota Corolla. Install floor shift parking lock cable assy
  5. Using a screwdriver, unlock the claw of the lock key of automatic adjustment part.
    Toyota Corolla. Install floor shift parking lock cable assy
  6. Insert the slide cap into the through hole and install.
    Toyota Corolla. Install floor shift parking lock cable assy
  7. Insert the lever pin into the hole in the cable end.
Hint

: fit the claws securely.
Toyota Corolla. Install floor shift parking lock cable assy
  1. Lock the lock key.
Hint

: at this time, the shift lever should be in n position and the ignition key should be set to acc or on.
  1. remove the accessory tool.

    Accessory tool parts no.: 33693–02010

13. Install steering wheel assy 14. Inspect steering wheel center point 15. Install horn button assy 16. Inspect srs warning light 17. Check key interlock operation

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.